Wingspan Egg and Token Box Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of https://www.thingiverse.com/thing:3614941 Box height increased, lid inlay added
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 152
- Wydruki
- 4
- Wyświetlenia
- 938
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
This remix increases the Z height pf the box to 105%, and fixes some of the mesh issues in the original file.
The lid also has an inlay added, which is optimized for 0.2625 layer height.
0. Either use a 0.2625 layer height, or else modify the inlay file to be exactly “1 Layer” in height
(You might be able to get away with just scaling the Z for the inlay and leaving the lid alone if your layer height is close to 0.32)
1. Add the inlay centre it, print with no brim
2. Keep the bed hot! Set your printer to heat up right after the inlay print is done
3. Remove the outer line around the print without removing the build plate (line is used for centering in Cura and other slicers)
4. Flip the cone tray lid 180 degrees and centre it, print with no brim right over the existing inlay on the build plate