Olympus E-PM2/E-PM1/E-PL5/E-PL6 Clip-in Filter Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Olympus E-PM2/E-PM1/E-PL5/E-PL6 Clip-in Filter Holder for the 1,25 inch/27,5 mm filters.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 783
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
I converted my little E-PM2 to full spectrum and needed a way to hold the filters between the lens and sensor. The only already made solution I could find was for the newer rounder mount of Olympus cameras.
So I took the opportunity to learned a little bit of CAD and made my own attempt for a clip in filter for the older Olympus M43 mount.
It can hold 1,25inch/27,5mm diameter filters in-between the lenses and the sensor.
I printed it with PETG and PLA, with 0.2mm layer height. No Supports where needed, depending on bed adhesion you might need brims. On my PEI sheet it worked without heeding them,