1 / 1
Wuben X-1 Falcon Gopro Bike Mount — zdjęcie 1

Wuben X-1 Falcon Gopro Bike Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for the X-1.

Ocena
0 / 5
Polubienia
5
Pobrania
60
Wydruki
0
Wyświetlenia
739
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a wraparound mount for the Wuben X-1.  Printed in PETG.  The GoPro mount should be easily editable to any other mount you may want.   The universal nature of the go pro mount means finding a mount to fit to your bike should be easy.   Personally I am using an extended “out-front” model that can be found here:  https://www.thingiverse.com/thing:2123857

The picture is in .3mm layer height, but thinner would likely look a bit crisper.  

The light is intended to be mounted under the handlebars, hence the button placement.  This mount really only fits on the light one way.  The gopro mount needs to be on the same side as the button.  The chamfers on the light are not all the same length.   One (near the lanyard attach) is shorter than the others.  If flipped, you will not get a snug fit.   

Print vertically so the layer lines wrap around the light itself.  

Fitting the mount over the light will require a bit of flexing the model, but I haven't had issues taking it off and putting it on. 

If you have suggestions for refining the model, comment below and I will make the revisions and reupload.    I am also planning a “rain” shroud for the fan and intake.  This page will be an ongoing project as I get time.

Tagi