1 / 5
Low profile anti-vibration feet for Prusa Mini+ base — zdjęcie 1
1 / 5

Low profile anti-vibration feet for Prusa Mini+ base

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Effective but not too high anti-vibration feet.

Ocena
5 / 5
Polubienia
11
Pobrania
39
Wydruki
3
Wyświetlenia
647
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

There are many models of anti-vibration feet for the Prusa Mini+ base out there. Most are either thin rubber feet (effectiveness questionable) or built on racquet/squash balls (effective but really high and wobbly). I figured, why not build anti-vibration feet using half balls. Half the height, almost not wobbly, and from what I can tell, still very effective.

Noteworthy:

  • I included two versions of the model: One in its original form, which would require supports to be printed correctly. I hate supports, so I added a sliced-open version that prints two halves without support. Once printed, use two pieces of filament to align the two halves (alignment holes part of model), apply superglue, and push together. Once done, pull out the alignment pieces.
  • The feet are designed for racquet balls with a diameter of 55mm.
  • Originally I had mentioned squash balls, but those have a smaller diameter of ~40mm. Turns out I had used racquet balls that were lying around the house, with a diameter of 55mm. I did some quick reading and it looks like racquet balls have a standard diameter of 57mm. For that reason, I included STLs for 55 and 57mm diameters.
    If none of those should work for you, you can adapt the “BallDiameter” in the attached Fusion 360 file and create STL files for your specific needs.
  • When slicing open the racquet balls, use a sharp, thin knife like an Exacto knife. And be EXTREMELY careful! Cutting through rubber, the knife can easily slip off and hit your fingers!
  • The protrusions on top of the feet are a bit underdimensioned for the cutouts at the bottom of the printer base feet, to allow for a bit of overextrusion on either side. You can either glue them in place, or use something thin like strips of paper as “shims” for a more secure fit.

Tagi