Skyrim logo necklace
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skyrim necklace intended for resin printing :)
- Ocena
- 5 / 5
- Polubienia
- 103
- Pobrania
- 426
- Wydruki
- 3
- Wyświetlenia
- 1711
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
A skyrim logo necklace!
Original model by: https://www.thingiverse.com/thing:3042456
I basically adapted it to a simple necklace, thicker, added proper support, an attachment point, topology fixes etc...
Printing!
I included my supported stl's as well as the sliced files for the anycubic photon S.
My print settings: (in use in the pre-sliced file)
Printer: Anycubic photon S
What to print?: 4 double sided skyrim necklaces at once
Time to print?: around 8 hours
Layer height: 0.02 mm
Quantity of resin used: around 20 mL
Type of resin: Anycubic Eco plant-based resin (macaroon pink and blue)
Printing temp: around 20C, the highest I could get at the time
Washing, Curing
I recommend removing the supports before curing. It's a bit more tedious with gloves and a mask, but they come off easier and there is less risk of damage.
also recommending to cure underwater, just tried with the last batch and they came out great.
Sanding
I started with 100 grit, then 150, 250, 600 grit.
Basically sand the supports marks until they are flat, then increase the grit to have a smooth finish.
Painting
I did two thin layers of black primer, then two layers of shiny chrome, short
/!\ WARNING /!\
I left the first three ones I printed on my desk in the sun before painting and they started to warp after 2-3 days. so maybe avoid leaving them in the sun before painting. (or cure them more).