Classical Vase (2 versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Large classical vase. Can easily be made waterproof!
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 319
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
Edit: Added a new version of the vase, with less steep overhang. It should be easier to print, especially with PETG which can be worse than PLA on overhangs.
This is a classical vase I designed to use in our home. It is not printed in vase mode, though you can do that if you want. The pictures show the first iteration of the vase, both flat skinned, and fuzzy skin. The uploaded file is the same, but at a higher resolution to make it perfectly round.
In the picture with the roses, the vase is filled with water, no post-processing was done. It is waterproof straight off the printer (though test it to make sure!).
To make it waterproof, follow the instructions further down.
If you print the vase, please post a a picture of it!
Edit: Picture of the grey vase is scaled to 70%.
Print Settings
To make it waterproof:
0.2mm layer height
No infill
0 top layers
5 bottom layers
First layer must be printed Concentric! This is the secret to make it waterproof.
5 walls.
Fuzzy skin gives it a real quality look!
Edit: A good, dense first layer, and enough layers on the bottom is needed to make it waterproof!