RaceWhoop 2 Inch AIO Mounting Hardware
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This contains a modified Bottom Plate and a 45 Degree adapter to use an AIO-Flightcontroller in the 2-Inch-Racewhoop
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 309
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This contains a modified Bottom Plate and a 45 Degree adapter to use an AIO-Flightcontroller in the 2-Inch-Racewhoop.
The BottomPlate enables some airflow and allows you to use a 45-Degree AIO-Flightcontroller. Ideally you would cut this from carbon fiber but can also be printed with Nylon/PETG etc.
The 45-Degree-Adapter can be mounted on top of the AIO and allows you to mount standard 20x20mm Hardware on top of the FC while still not thermally choking it.
Should not be printed in PLA as it can get too warm for PLA.
I used this to mount a 35A AIO-Board and a 20x20 VTX on top of it.
Notes:
If you can, cut the BottomPlate from CFK, if you can't then print it solid.
The adapter needs to be printed in a filament that is heat tolerant