Spinning letter I (print in place)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A letter I that has another I in it that spins.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution
I designed a spinning letter I after the first letter in my name. I! These models are in the shape of a large but hollow I and a smaller one spins inside of it from the hinges in the middle of the I. Feel free to remix or sell these however you like.
The lt and the tt at the end of the model name separate the two versions. The lt stands for loose tolerances and is better in most scenarios. For me, the loose tolerance one was able to freely spin for a few seconds. The tight tolerance one (tt) was also able to spin, but it would not spin freely on its own like the loose tolerance one. The advantage is that it wiggles from side to side less. These models are print in place and require NO supports. For me, these took about 2 hours each at full infill. It is a simple print that most printers should handle without any problems. Enjoy!