Mount for LED Light Bar and controller on Ender 5+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modeled to mount a light bar on an Ender 5+ 2020 front bar and the controller to the front of the 2040 upright.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I needed a way to mount a light bar I bought on amazon, https://amzn.to/3xAyZcK , to mount it to my Ender 5+. Originally I had it mounted to the front of the front bar but as I have dropped the front bar down and wanted the extra clearance I found they also worked for the top of the bar with only a little bit of the sides covered not shading much if any of the build volume. I next wanted to mount the controller which is in line on the wire but leave the area directly behind it to route the cable from my webcam to keep the wires together and tucked into the extrusion as much as possible.
The light mount uses m4 or m5 screws, pretty short ones maybe x6mm, and either a roll in or hammer head nut. The Controller clips onto the 2040 extrusion and is a pressure fit on the controller that snugs up once you clip it on.
Both are a quick print using very little material. The light mount should work even with light infill and the controller mount is so small you are unlikely to even get infill with a 0.4mm nozzle since the walls are only ~1.2mm thick in most places. The controller mount may need a brim depending on printer and material.
No supports should be needed and files are oriented with the correct side down.
Step files included if you want to make adjustments or remix.