1 / 7
Magnetic Yin & Yang Chopstick Holder Set — zdjęcie 1
1 / 7

Magnetic Yin & Yang Chopstick Holder Set

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

0,88 € – 1,08 € netto (bez VAT)

Dla pliku: Yin_or_Yang_CS_Holder.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,98 € netto (środek widełek).

Masa podana przez autora
5 g
Czas druku podany przez autora
1,33 godz.
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Choose Yin or Yang or find your balance with both.

Ocena
0 / 5
Polubienia
20
Pobrania
24
Wydruki
0
Wyświetlenia
223
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Made for the Chopstick Holder Competition 2023.

As I have previously made a Yin and Yang Catch All Tray, this was an obvious design to follow. I added a twist by making each half magnetic. Choose your balance!

Print 2 of each file for a full set. Choose two contrasting colours.

Assembly is super simple.

The parts take four 4 mm diameter by 2 mm thick neodymium magnet. They are simply added after printing* with a tiny drop of glue. Make sure you check alignment before gluing or your yin and yang might fight each other! Please be aware that even these tiny neodymium magnets can be dangerous for children if swallowed so leave out if you are at all concerned.

*I tried dropping the magnet in mid-print but it is too complicated to ensure correct alignment with these tiny magnets - they tend to flip over. It is much more successful to test that everything works properly before adding a tiny drop of glue over the top of the magnet.

Optionally, a small spot of glue on the centre circle helps keep it fixed. I used superglue for all.

I printed in PLA with a 0.4 mm nozzle at both 0.12 and 0.2 layer height - no noticeable difference in quality. Infill is fine 20% as these are carrying very little load. Each half takes about 1 hour to print and about 1.78 m of filament.

 

 

 

Tagi