Multipurpose Soldering Jig for RPi/WeMos/etc.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
General purpose soldering jig for RPI/WeMos/etc. parts. Snappable supports so you can customize to fit.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 2
- Wyświetlenia
- 304
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a multipurpose soldering jig to help with soldering headers on a small selection of devices that I use a lot. This jig has slots for 20x1 and 20x2 (raspberry pi) standard 2.54mm male/female header strips (works for both). It also has a pair of 8x1 slots spaced apart for the WeMos D1 mini board. Drop the connector in the slot, drop the board on top, solder away.
The height is set so that the board will lay flat while you're soldering, and the square support pins are thin enough that if you needed to break one off to make room for a low-hanging component you can do that easily. I printed several and snapped the tabs off for various common boards.
If you have a larger board that won't sit level on this jig just print a couple of jigs and sit them next to each other to level it out.
Comes in handy.