Steam Deck Low Profile OC cooler for JSAUX transparent shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep those temps down after Overclocking your Steam deck with this small but capable OC cooler with its own Powersource
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 3418
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
The OC cooler in combination with a non destructive Thermal Mod + JSAUX backplate will keep the temps on your overclocked Steam Deck under control giving you enough headroom to not worry about stressing your device with to much heat on the die.
Components you need for this build:
Lithium Polymer battery( any lipo battery with the same measurement will do:
https://www.amazon.com/Dromida-700mAh-Ominus-Quadcopter-Battery/dp/B00NVSTOSM
USB C Lipo charging board with protection:
https://de.aliexpress.com/item/1005001998316377.html
30x30x10mm 5volt fan:
https://de.aliexpress.com/item/32407532684.html
ON/OFF switch SS12F15 5mm:
https://de.aliexpress.com/item/1005003938856402.html
50,8 x 50,8 x 16,51 mm Heat sink:
https://www.reichelt.at/at/de/kuehlkoerper-50-8-mm-alu-7-6-k-w-pga-ick-pga-20x20-p227830.html
Or search for: “ICK PGA 20X20” and source it from wherever it is easier for you as it is quite specific.
50x50x1,5mm Thermal Pad 14.5W/mK:
https://www.amazon.de/dp/B084V87RGP
( OPTIONAL) Generic Steam Deck TPU sleeve:
Check pictures above to see what modification I did to the Heat sink to make the fan fit inside it! I used pointed pliers and twisted/ pulled every single heat sink “tooth”.
Use thinner cables then the battery comes with to make it fit inside the case.
Connect the battery to the charging board and also the fan with the switch in between, this is straight forward and should be pretty much self explanatory, the PCB is nicely marked where to connect the battery and where the outlet is.
The 5 volt fan is directly driven from the Lipo battery without a booster. On 5 volt the fan can get pretty noisy.
for this Mod to work efficiently you have to do the non destructive thermal modification on your steam deck, check the video on the bottom of the page to see what you need to do!!!
THIS IS VITAL FOR THIS COOLER TO WORK AS INTENDED!!