Bambu Labs P1P - PTFE Passthrough Larger Hole Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the design by andrew brady. All I did was make the hole larger for the PTFE to fit through easier.
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 342
- Wydruki
- 2
- Wyświetlenia
- 1577
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
This piece reroutes your bowden tube so that you can use a top panel/enclosure. By default the bowden tube runs over top of the frame of the printer. This piece will allow it to run inside without the risk of damaging the bowden tube.
This design is a remix from andrew brady. All I did was load the original model into TinkerCAD and stuck an empty cylinder into the hole and made it larger to cut a bigger hole in the model. Fits my PTFE tube perfectly now.
I would recommend printing it out of PETG in case you decide to do a full enclosure in the future just to be safe with the higher chamber temps but PLA would honestly probably be fine.