Momentary switch bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this to hold the momentary switch for my flashlight on to an M-lok handguard. AIRSOFT ONLY
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 156
- Wydruki
- 1
- Wyświetlenia
- 586
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduction :
This is a replica of the “tactical M-lok / Keymod pocket panel” by WADSN to hold a momentary switch on a handguard.
You will find two versions, one with the same length and hole placement than the original (in black in the pictures) and another one which is made for an M-lok handguard from Specna Arms (in gray). The second version uses M5 screws, 100 mm apart, and uses the holes already tapped on the handguard (example in the photos).
Hardware :
for the M-lok version :
- 2 * M4 by 12 mm screws
- 2 * M4 T-nuts / Magpul hardware
For the other version :
- 2 * M5 by 8 mm screws
Print instructions :
Prints as displayed
I used my Anycubic Kobra, and it took around 40 min with these settings :
Supports : yes
Rafts : if your bed isn't really sticky
Layer height : 0.20
Infill : 20%
Perimeters : 3
Bottom and top layer : 4
Print speed : 60 mm/s²