6mm Bit Driver for Victorinox 91mm SAK

Introduction

This is a 6mm (1/4 inch) hex-bit driver I made for my 91mm Victorinox SAK. It will only work with 91mm Victorinox knives, but I also made one for 111mm knives.

I tried to make it as durable and universal as possible, and it can be used for both light- and mid-duty tasks without problems. It can be printed both vertically and horizontally, with horizontal (the default position) being the more durable one according to my tests.

Feel free to modify it as long as you credit me, as the item is under "Creative Commons - Attribution".

I did my research into the smallest footprint possible while still being durable, and this is what I was able to make based on that.

It fits on the flat-head/prybar/cap-lifter tool of the SAK. It's also made to lock-in into the tool (with a neat click sound!) for more versatility and less accidental discharges.

The different versions

• 91mm (This one) - made for the screwdriver/prybar/cap-lifter of the 91mm SAKs. The most durable and versatile one because of that.
• 111mm liner-lock - https://www.printables.com/model/285471-6mm-bit-driver-for-victorinox-111mm-sak

To check what kind of screwdriver/prybar/cap-lifter you have, check this page: https://www.sakwiki.com/tiki-index.php?page=Cap+Lifter

Print Settings

Printer Brand: Creality

Printer: Ender 5

Rafts: No

Supports: No

Resolution: 0.12

Infill: 85-100%

Filament: Herz PLA NATO Green

Notes:

Only works on 0.12 resolution if printed horizontally due to the bit-driver slot needing the higher resolution to be printed. If you want to print on lower resolutions, (like 0.2, 0.28, etc.) you need to print it vertically. It prints vertically by default.

Post-Printing

Installing a magnet

After printing you can install a magnet in the 6mm (1/4 inch) hex slot if you'd like, but it's not required and still provides a snug fit without it.