FT BTT Pi TFT50 screen mount (Voron Switchwire/2.4)

** Made some edits to the design so you can now use the original M2 screws that come with the screen. I also adjusted the gap between the 2 mounting holes as they did not align 100%.

This is a screen mount for the BigTreeTech Pi TFT50 touch screen to be mounted on the Voron Switchwire or the Ender 3 conversions. This screen is powered directly from the Raspberry Pi ribbon cable and best of all its plug and play - no 3rd party drivers need to be installed. You will need to purchase a longer ribbon cable depending on where the Pi is mounted under the printer. There are no drivers/software that need to be installed!

Assembly

1. Pass the ribbon cable through the cutout if the Frame Rear and attach it to the screen. Its a good idea to power on the Pi to be sure the cable is attached correctly and that the screen powers up and displays correctly.
2. The screen will need to be mounted to the frame using 4 x M2x3 screws that comes with the screen.
3. Use 2 x M3x20 screws to mount it to the grill from the inside.
4. ENJOY!

If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :) 

Should you have any questions you can reach out to us via Discord

Please help me and upload a make if you are happy with my design :)

CHANGE LOG

26-Oct-23

1. Fixed some missing fillets on some of the hexes.

24-Sep-23

1. Updated BTT Pi TFT50 V2.0 to make the opening for the dial and button smaller
2. Added support for BTT Pi TFT50 V2.1 (wider opening for the buttons that replaced the brightness dial).