Jart / Lawn Dart fins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Coworker needed replacement fins for his lawn darts.
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 1246
- Wydruki
- 2
- Wyświetlenia
- 6381
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
Coworker needed replacement fins for his lawn darts. The ones I could find weren't ideal for his specific model so I created these. I believe his was one of the "Jart" brand models.
Printed this in 95A TPU and it worked great (with fin support listed below). Good balance between stiffness and flexibility for the fins.
Two files - One with just bare fins, and one with added support towers on the fin edges, as the fins are thin and when I printed in TPU it would tend to flop around enough to fail the print. Cut the towers off with some decent shears/shop scissors.
I did use a brim and auto-generated support in Cura to assist with the bottom of the fins, and the raised center.