Winnebago Draw Catch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the part of the catch that is fixed to the non-movable section of the cabinet and screwed to the face frame.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
Winnebago Drawer Catch
This file creates the fixed half of the draw catch that's used in my Winnebago RV. This part attaches to the bottom of the top rail for each of the draws on the kitchen cabinet.
It should be printed in the orientation as shown on the .stl file for maximum strength.
I used Nylon filament for maximum strength. Other filaments could be used, but with the success I had with Nylon, I didn't pursue other options.
I printed these with the following parameters :
- 3 top and bottom layers
- 5 perimeters
- 90% infill - gyroid infill pattern.
I have replaced three of the originals already, and they seem to be holding up just fine. Apparently, they're probably as good as those originally used. If not it's easy enough to print out more of them if needed and a lot cheaper as well!