MIC Maono AU-PM360TR Shock Mount (2 parts only)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 2 parts minimalist simple Shock Mount for Maono AU-PM360 Mic using its original mic stand. The original table mic…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 584
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
A 2 parts minimalist simple Shock Mount for Maono AU-PM360 Mic using its original mic stand. The original table mic stand has a lot of boom sound. Since I still prefer a table mic stand, adding a shock mount will be a perfect solution.
Just print the 'MIC Holder inner Shock Mount' and attached on the MIC bottom screw and tightened it using the existing table mic stand holder. Future add on possible to design a wind shield attachment too. But the MIC sponge is more than adequate.
Use some rubber or elastic band to go thru the inner shock mount for top and bottom holes. Then print the 'MIC outer Shock Mount'. Then just pull out and attached at the outer shock mount. Attached the 'MIC outer shock mount' on to the existing Maono table stand.
Tested and no more boom sound from table knocks or even keyboard typing .
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm
Infill:
40
Post-Printing
Category: Audio