LiTime 50Ah Battery Terminal Cover and Stacking Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cover for the LiTime 50Ah Batteries allowing for Cell Stacking
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 657
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is designed to allow LiTime 50Ah batteries to stack on top of each other as well as protect the terminal. It's a bit overkill if you are only trying to protect the terminals, my TPU Battery Cable Boots would be better for that. If you want to stack a couple batteries or have a flat surface above then these might be what you're looking for.
The “Side” part can be mirrored to cover both ends of a battery. If you want to string multiple in series that's where you'd want the “Middle” part as well. The parts have small nubs on them to help them snap in place to the battery handles and stay put reasonably well. They don't do anything to help keep the stacked batteries in place so you'll want to fasten and secure the upper batteries in place somehow. I wrapped a large strap around mine once I put them in place (not pictured).
I don't know how many batteries you could stack together using these but they seem reasonably strong and I would assume a stack of four would hold without issue.
I used a textured PEI print surface and they look very nice once completed.
Print Details | |
|---|---|
| Layer Height | .20 mm |
| Infill | 20% Gyroid |
| Supports | None |
| Filament | Overture Black PLA |