NA NB Miata Throttle Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Throttle extension for heel/toe shifting.
- Ocena
- 5 / 5
- Polubienia
- 75
- Pobrania
- 554
- Wydruki
- 4
- Wyświetlenia
- 3007
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
This is my take on a Miata throttle extention. Makes heel/toe shifting easier for my small feet. It adds 25mm to the width.
I printed the one pictured in ASA, I also printed some prototypes in ABS and both seem strong. I used M4 heat-set inserts and button head screws.
This was designed to be printed upside down as shown in the photo. No supports are needed. You should probably use a 5mm or so brim. I was able to print one without a brim but it wasn't as clean of a print. I printed at 0.2mm layer height and 50% infill. Lower infill prototypes also seemed fine.
I'm not the best at CAD. I designed this by taking some pictures and traces of the pedal and importing those into Fusion 360. It wasn't perfect but with a few tweaks I'm very happy with the result. I have included the source file from Fusion 360 also. I used parameters where I could to make tweaking things a little easier but it's still a house of cards. Make changes at your own peril.