Milwaukee Packout Compact Organizer Handle Labeling System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement handle for the Milwaukee compact organizer that accepts an interchangeable label.
- Ocena
- 5 / 5
- Polubienia
- 206
- Pobrania
- 856
- Wydruki
- 1
- Wyświetlenia
- 9455
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement handle for the Milwaukee compact organizer that accepts an interchangeable label. The handle works the same way as the original handle — it locks in both the folded and extended positions. The label slides into a dovetailed groove on top of the handle from the left side.
I’ve provided an STL for the handle and for 5 different labels. If you want other labels you need to edit the model in openSCAD. I have some generic instructions on how to do that here.
Print with Supports.
Installation:
To remove the original handles use a flathead screwdriver between the outside of the hinge and the case to push the metal pin towards the center. Then use a pliers to pull the pin the rest of the way out of the hinge. Once you pull the pins for each side the handle should fall off.
To put the new handle on, position the handle so that the hinges line up and push the pins back in.
The labels slide into the handle from the left. If they are too loose you can use a spot of glue on the right side to hold them in place.