Strala Lamp (DIY)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple and good-looking lamp for the lamp suspension Strala (available at IKEA).
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 86
- Wydruki
- 0
- Wyświetlenia
- 970
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to design my own lamp and this is what it turned into. I decided on two versions, with a diameter of 150mm and 180mm.
Parts needed
- 1x Strala lamp suspension from IKEA
- 1x E14 LED
Print
The three parts don't need supports and should already be correctly aligned on the print bed. I printed my parts in Pla with a 0.4mm nozzle and a layer height of 0.2mm. The lampshade(P3) needs to be printed in vase mode.
The printing time in my case was 7:30h for the Ø150mm lamp and 8:30h for the Ø180mm lamp.
Assembly
The Strala lamp suspension is screwed into the connector piece(P2) and glued together with the base piece(P1) in the notch at the bottom. The cable is led through the cutout. Now an LED can be screwed into the lamp suspension. In the last step, only the lampshade(P3) must be carefully pressed into the connector piece(P2) and the lamp is complete.
I hope you like my model, it was a great experience and fun to design.