Bearing Holder for Polymer Bearings like RJ4JP-01-08
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holds a polymer bearing sized for an 8mm rod.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is remixed from a model by Jori available here: https://www.printables.com/model/110363-sc8uu-replacement-for-igus-drylin-rj4jp-01-08-lm8u
The goal of this variation was to allow the 4 corner bolt holes to be used for mounting & assembly purposes, without interacting with the tension applied to the bearing.
My attempt here uses a single bolt to adjust preload on the bearing. That flexing piece moves independently.
I added a 6th bolt hole, in the middle of the other side, for symmetry.
I haven't used this yet, but it prints well enough with a small support in the middle (not included). I need to reprint it in PETG shortly, then I will share photos.
Full model available here (I'm new to Onshape): https://cad.onshape.chttps://cad.onshape.com/documents/f4ad08578ac4c5c0d41a7a56/w/c51a2c130d3762a530be1b10/e/d247a6a082f7e9a58a7ea8be?renderMode=0&uiState=63fac0891734342db4e01870
