Ender 3 to Biqu H2 Direct Drive Conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As the Title Says this is a Direct drive conversion to the BIqu H2 Extruder hotend Kit
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 686
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Edit:
Redesigned the fan housing and Air vent to give better airflow as I noticed that the air was stalling on the first revision. let's just say I learnt a lot since I first published the model.
I started this looking for a mount for my H2 Upgrade with several requirements:
- It must be an easy upgrade, no special insert required.
- It must be suitable for the BL touch,
- Needs to ensure the Blower does not obstruct the functionality of the Direct drive unit,
- Use as little support as possible.
to this goal I think I've achieved.
The BLtouch mounts with M3 Nuts, everything else need no further screws that what up should have, both that comes with the kits Aswell as the left-overs from removing the old hotend and fan unit.
the only other thing needed is a cable tie for the wire harness .
the only on I used supports for is the 40x20 blower housing
hope you enjoy it, And let me know if you have any issues.
although I took a lot of inspiration from a lot of sources, this is all my own Designs and can share the Step files if requested.
Regards.