1 / 2
Small Powerbank 21700 (1-2 cells) 18W PD QC — zdjęcie 1
1 / 2

Small Powerbank 21700 (1-2 cells) 18W PD QC

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure for a small power bank with a single/double 21700/18650 cell and SW6106-based charging board

Ocena
5 / 5
Polubienia
20
Pobrania
79
Wydruki
1
Wyświetlenia
1300
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Public Domain

Powerbank with 1/2 21700 cells and SW6106 board.

You'll need:

  • 21700 cell (2x for 2P model) capable of at least 4A charging and discharging (pretty much any, but 5Ah are preferred of course). 18650 should also work, though does not make much sense since the board is exactly 70mm long
  • SW6106 board: https://www.aliexpress.com/item/4001220747666.html

Notes:

  • Board supports 12v 1.5A discharging and about 12v 1.2A charging using common charging protocols (QC at least, maybe also PD, though not checked). 5v/9v with higher current is also possible.
  • No BMS needed: board charges to 4.2v (can be set to 4.25/4.3/.. also using a resistor) and cuts off at 3v (which sucks since all normal cells can go down to 2.5v, so we lose about 10-15% of charge)
  • No hole for button to show charge - feel free to remix and add. Charge is shown anyway when you plug something in

Assembling:

  • Print an enclosure and two lids
  • I've used double sided tape to attach the board to the battery
  • Solder/weld the board to the cell. I've used two small pieces of nickel stripe that I welded on and then soldered the wires to them
  • For 2-cell version you need to solder/weld the cells in parallel before connecting them to the board
  • Insert into the enclosure and fix with some hot glue
  • Use normal or hot glue to fix the lids on both sides

Update:

  • Was made 2mm longer for easier fit
  • Holes adjusted to match LEDs

Tagi