Huawei 3 pro watch charging stand

A charging stand I made for my Huawei watch 3 pro.

It fits the charger perfectly, and you can run multiple cables through the side gap in the stand as a cable organizer.
the stand on itself stands perfectly (without or without the watch), doesn't get lifted when removing the watch, but just to make sure I don't knock it off, I added some holes at the bottom to add weights, but later switched to the idea of adding Bluetack (sticky tack) in the 2 circular holes which made the stand stick perfectly to my nightstand.

Note : 
I printed the 2 parts presented in the gcode separately but it should print well with both at the same time.
You can cut the full model at 65mm in Prusa slicer for the same results (supports on print plate only, 5 perimeters, 15% gyroid infill for upper part, 40% gyroid on the bottom part).

 
hope you enjoy it as much as I do.
if it was helpful for you, please share your images and review on the model and maybe consider a small donation <3.

Happy printing.