PicoMite VGA case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for a PicoMiteVGA
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 798
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
The PicoMiteVGA is a small computer based on a Raspberry Pi Pico that runs BASIC and outputs to a VGA display. It's mostly developed via TheBackShed forum: link to PCB and discussion here: TheBackShed.com - PicoMite VGA Edition PCB - release version - Forum
Only the case base, top and blank end panels are included here. My cutouts were too ugly to share. I've included a 2D DXF for you to work out your own layout.
This design is a kinda-sorta Multicomp G738A functional knock-off, except it only has screw holes in the base that are a subset of the real design. I also baked in M3 hardware, while the original prefers M2.5. I used nylon machine screws so I could trim them to length.
If you use the same RTC board I did, you may need to file the print at one post a little to improve the fit.
I printed this in PLA. You may need to include selective support around the nut catches in the top of the case.