1 / 3
Choke Lever and Flap for an Echo SRM225 Trimmer — zdjęcie 1
1 / 3

Choke Lever and Flap for an Echo SRM225 Trimmer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the choke lever and flap for an Echo trimmer which was featured on one of my videos.

Ocena
0 / 5
Polubienia
3
Pobrania
164
Wydruki
0
Wyświetlenia
1013
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These parts are for an Echo SRM225 trimmer.  It is the choke lever and the choke flap.  These parts have been slightly modified from the OEM parts.

You will need to remove the factory pieces completely.  You will need a #8 x 0.5 inch machine screw to complete the assembly.

I used black ASA for the flap and orange PETG for the lever.  I would have used ASA for the lever if I had orange ASA filament.

I printed the parts using a Bambu Lab X1C with standard settings.

I also printed the PETG part on an Ender 3 Pro (modified) using 250 degree nozzle and 70 degree bed at 60 mm/s.

These parts are shown on two Youtube channels:

Think Design Make (a new channel!)

&

Small Engine DIY  

Tagi