Embroidery Floss Organiser Cards
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I love a good organising tool so although other folks have made some great, similar stuff for needlework enthusiasts…
- Ocena
- 5 / 5
- Polubienia
- 53
- Pobrania
- 199
- Wydruki
- 2
- Wyświetlenia
- 1281
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
UPDATE
A little organisation goes a long way. In the process, I realised that an alternative version of the Multi-Floss Organiser, with a thread saver component, was much more useful than the original version. Have included the new version here but leaving the old one too in case there is a preference.
I've also added a combi Bobbin and Thread Saver and a mini Bobbin to my set of thread organisers. You can find both here on Printables too.
------------------------
I love a good organising tool so although other folks have made some great, similar stuff for needlework enthusiasts and makers, I simply couldn't resist making one that suited my own embroidery needs.
There are two kinds of embroidery floss cards that I'm sharing:
- A multi-floss organiser when you have not-quite-enough floss for the standard size bobbin card but still too much to store anywhere else. Mmm, if only you had a half-size bobbin card...wait! You do now! And since we're at it, why not throw in another couple of spaces so you can keep similar colours together?
- A project thread saver for when you are working on a project and need to keep a few pre-cut lengths handy. There are also some tiny spaces on this card to keep double and single thread scraps from getting tangled or lost elsewhere.
Hopefully there are other uses for them too...I'm looking at you fishermen (who also need to organise your rigs).
As with everything I've designed, I'm still pretty new at this so I'm learning as I go. These cards are pretty simple so hopefully easy to print if you decide to use them but feel free to message me if you have any issues.
Print Settings
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
No
Supports:
No
Filament: Amz3d PLA
Notes:
I sliced my model in CURA v5.0.0 with the following settings. I don't know if these are the best but they worked for my purposes:
-Layer Height: 0.175mm
-Wall Thickness: 1.05mm
-Top/Bottom Thickness: 0.72
-Infill Density: 22.0%
-No supports or build plate adhesion
Category: Organization