Adderini cocking lever reinforcement & grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reinforcement for the two part cocking lever. Mine broke so I made this part to strengthen it.
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 383
- Wydruki
- 1
- Wyświetlenia
- 4360
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
There are two versions are available: Large and small. I personally prefer the large version.
Especially the large version creates a good grip and makes the handle more comfortable to use. You can use it as a handle while aiming / shooting.
Print the part on it's side with supports in between. Although this orientation makes removing the supports quite difficult, it will make sure the part is as strong as possible.
After removing the supports slide it onto the cocking lever to make sure it fits snugly. It might require some strength to make it fit. (you can use some pliers to push it on)
Once you're sure it fits correctly, remove it and add a good amount of super glue onto the part before installing it permanently.
(Should also work with the MiniAdder I think)