PVS-7 adjustable Dovetail mounts

This adapter allows you to mount your PVS-7 to modern dovetail interfaces. included are 2 versions, to either place the Dovetail on the under- or upperside of your NVG.
with this it is possible to attach your PVS cheaply and pretty securly with the use of repro Wilcox G24 mounts. (I personally use the sotac one)
to ensure tight fit with as many mounts as possible, there is an adjustable screw encorperated into the design. This mechanism was inspiered by the adjustable thightness dovetail J-Arm made by radiactive (https://www.thingiverse.com/thing:5437655)

### Needed materials

2x M4 Bolt (overall Length 22mm, Thread lenght 18mm)
2x M4 Nut
1x M3x30 bolt 
1x Ballpoint Pen Spring


### compatibility 
tested with 
 Sotac g24 repro 
 DIY Rhino II PYRM
 Repro LNVG mount
 Lowsto repro mount

### Printing
You should have a pretty good calibrated printer to start with, specific settings aren't that important, as this adapter recieve to much stress.
I printed my example with a wall count of 16, but i don't believe this is really necessary. The reccomended print oriantation can be seen in the "print orientation.png" in the media folder.
After printing remove the supports structures and put in the M5 Nut and the M5 Bolt, put the adapter on your Nvg and thighten the screw until the adapter is secure.
You will need to screw in the M3 Bolt into the locking block, this can be kinda tricky, i recommend you do it first outside of the adapter and then undo it to insert it only after you already started cutting the threads in the locking block.
The filament i used is Esun PLA+.

 printer settings
 nozzle size  0,4mm
 layer height 0,2
 Nozzletemp  205-225 (whatever works for you)
 Bedtemp   60 (whatever works for you)
 walllinecount 30 (whatever works for you)
 supports   enabled