EDF 4.1 Fencer Helmet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printable Fencer helmet from the game Earth Defense Force 4.1.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 923
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A printable EDF 4.1 Fencer helmet, pre-separated for your convenience!
There is a “neck test” you will want to use so you don't waste a ton of filament and time printing a helmet that's too small, as the neck hole is almost certainly going to be the limiting factor of how small the helmet can be if you want to wear it. I would make it so that the neck hole is 1-2cm wider than your neck. Print the separated neck test files, and then put them together around your neck. My neck is about 101.5mm wide, you may be able to scale the helmet based on how that measurement compares to yours.
You may need to scale some parts by a factor of 1,000, not sure why they exported from blender so small.
The parts need to be separated into the 4 main pieces shown in the pictures or you won't be able to put it on. I used the technique in this video to secure the pieces together:
Basic print settings I used:
0.4mm nozzle
0.2mm layer height
100% infill
Tree supports
I'll be updating this post as I continue working on the helmet. Feel free to comment if you have any suggestions of changes I should make!