PC Cable Management Clip Print-in-Place
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A print-in-place clip for PC cable management to save your supply of zip-ties
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 174
- Wydruki
- 2
- Wyświetlenia
- 1322
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
After burning through zip-ties while cable managing my PC i decided to do something about it and made this print-in-place clip so i never need to use zip-ties again
It is big enough to hold even the larger cables in a PC like USB 3 front pannel cables and 6 and 8 pin PCIe / 4 and 8 pin CPU power cables but at only 16mm wide it shouldnt stop you getting your side pannel on even on cases with very little room behind the motherboard tray
It can be printed with a 0.6mm nozzle but a 0.4mm or smaller is advised, there is a small ‘support stick’ on the inside corner of the clip body that needs to be trimmed away with side cutters, but as a bonus the friction from the remains of the stick give enough resistance that the clip doesnt close untill you close it
The 'Low Tol' version will need a 0.4mm nozzle or smaller and a well dialed in printer, i recommend printing one of each and see which one works best for you
Known results:
Ender 5 Plus (not 100% dialed in): ‘Regular’ 100% success rate 10/10 working, ‘Low Tol’ 60% success rate 8/12 working
Bambu Lab P1P: ‘Regular’ 100% success rate 1/1 working (very loose, not recommended), ‘Low Tol’ 100% success rate 31/31 working
Print Settings:
Standard Cura settings for PLA, 0.4mm nozzle, low quality preset (0.28mm) unless specified
Minimum wall line width: 0.3mm
Initial layer horizontal expansion: -0.1mm
10 top and bottom layers (to make it solid)