1 / 6
Finger Wrench for Primal Rights Competition Primer Seater (CPS) — zdjęcie 1
1 / 6

Finger Wrench for Primal Rights Competition Primer Seater (CPS)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A finger wrench for snugging the screws for the shell plate holder on a Primal Rights CPS.

Ocena
0 / 5
Polubienia
3
Pobrania
29
Wydruki
0
Wyświetlenia
435
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The user manual for the Primal Rights Competition Primer Seater (CPS) says not to use tools to tighten the shell plate holder screws — finger tight only! In practice, I've found “finger tight” to be barely sufficient. While it's unnecessary to crank down on these screws (and, as the user manual suggests, may damage the elevator assembly), I do find it useful to snug them just beyond what I'm capable with just my fingers. For that reason, I designed this finger wrench for this specific purpose.

The CPS finger wrench is designed to fail before excessive torque is applied to the shell plate retention screws. If too much torque is applied to the wrench/screws, it will either strip the hex nub on the finger wrench or the wrench will fail at the base of the hex nub (this area is intentionally thin/designed to be a weak point), or both. Please note: I have not actually attempted to test this function and strongly advise against applying excessive torque to the shell plate screws with this wrench.

The model has an optional internal magnet pocket for embedding a 9.5x3.2mm disc magnet during the print. If oriented correctly within the print, the CPS Finger Wrench can also serve as a tool to remove the flush plug from an InLine Fabrication Flush Mount Quick Change Base Plate.

 

Using the CPS Finger Wrench:

Best practice is to thread the screws in finger tight and then use the finger wrench with only two fingers (thumb and index, for example) to lightly snug the screws beyond finger tight; about 1/10th of a turn.

 

Print Recommendations:

  • A 0.25mm nozzle at a 0.1mm layer height is recommended for better resolution of the knurling on the wrench.
  • Nozzles larger than 0.4mm and layer heights higher than 0.2mm should be avoided.
  • Print text-side down.
  • Use a print pause at the appropriate layer height if you choose to use the optional embedded magnet.

Tagi