BLtouch cable bracket for the Fokoos Odin3 3D printer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This bracket mounts on the right side idler mount of the Odin3's X gantry for better cable management.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 223
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Fokoos Odin3 uses ribbon cables that don't provide a cable management method if you install a BLtouch or other leveling probe. I designed this bracket to mount on the right-side idler assembly so that the cable could be routed to the MCU board via the cable entry on the right side of the case.
The plate the bracket mounts to is 3mm thick. I designed this to have a 2.5mm wide gap for mounting to ensure a very tight fit. Because of that I suggest printing it in PETG since it will deform to fit with less chance of snapping when forced onto the plate. It printed fine without a brim with the top against the bed.
I've included the STEP file should you find the gap too narrow or want to modify the design.