1 / 4
Duet3D Magnetic Filament Monitor Mod V2 — zdjęcie 1
1 / 4

Duet3D Magnetic Filament Monitor Mod V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a modified idler assembly for the Duet Magnetic Filament Monitor.

Ocena
5 / 5
Polubienia
14
Pobrania
76
Wydruki
0
Wyświetlenia
1079
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This is a modified idler assembly for the Duet Magnetic Filament Monitor. The original one had a lot of space for the idler to move around within the housing (as seen in the photos) and it would allow the bearing to move off of the filament and cause a lot of false readings.

With the assistance of my friend DSK (https://www.prusaprinters.org/social/1022-dsk001/prints), we have come up with a modified idler that keeps the bearing in place.

Print this model twice, then place them together over the bearing. There is no need to glue it together, it will just sit down into the slot as shown in the photo. Once the housing is reassembled it will hold the idler together.

This new idler will greatly increase the reliability of the Duet Magnetic Filament Monitor. I've had no false triggers since using this new idler.

Here is the link to the Magnetic Filament Monitor https://www.filastruder.com/collections/electronics/products/duet-magnetic-filament-monitor

If you would like to try my V1 mod that can be found here. https://www.prusaprinters.org/prints/41245-duet-magnetic-filament-monitor-mod

Print instructions

It's a simple print, almost any slicer setting will work, takes about 6 to 10 minutes to print.

You will need to print two, then put them together over the bearing.

Tagi