GoPro HERO10 Bones 10mm Carbon Fiber Tube Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of clamps for mounting a GoPro HERO10 Bones on 10mm carbon fiber tubes.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
UPDATE: tying the skids together like this resulted in some rather ugly vibrations/resonance. I made a new mounting solution to replace this one. Leaving these files here since the parts can be adapted for other uses.
A set of clamps for mounting a GoPro HERO10 Bones on 10mm carbon fiber tubes. Should adapt to other naked GoPro or even full GoPro models fairly easily. The screw holes are 3mm, with one side taper-bored for a 6mm long heat set insert.
So long as part cooling is very good, the 10mm Tube Clamp can be printed without support. I elected to print it rotated 45-degrees (resting on a long edge) with supports under two faces.
The GoPro clamp should be printed with the 10mm hole facing up, using supports under the smaller 3mm GoPro mounting tabs. The STL may need to be rotated 90 degrees - my apologies if that is the case.
The Fusion 360 archive file is included should you wish to reimagine the parts for other use.
Recommend PETG, ASA, or nylon for durability.