Ender 3 Dial Gauge Mount X-Z Combination
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combination of X and Z mount for Dial Gauge.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 473
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to tune my Ender 3 V2 and found this model. As I can't mount the Z-holder on my printhead, as it is supposed to be, I remixed the X-holder and added a holder for the Z direction.
My first design was to just copy and paste the gauge-mount, so supports are needed.
But then I had the idea how to make it supportless. You just need a longer screw.
You can find both versions in the download section.
One downside still is, that the clamping mechanism is not supported by default (I used support from buildplate only) and so it may be closed and you cannot clamp your gauge like in the original design.
In my case clamping was not necessary, as it was a tight fit - I had to add some tape on my gauge anyways, because my gauge has a diameter of 8 mm and the design has 9.6mm. So a 9mm shaft on your gauge will word best, or use some tape around the shaft...
I hope this model helps someone! If so, please like and post your make!
Thanks