1 / 2
Parameteric Minimalistic Tracker Disc
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Customizable, Disc-Shaped Tracker for Points, Health or other stuff. Print-In-Place and fast to print.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 460
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 2)Remiksy (0)Kolekcje (23)Powiązane
I wanted a dead-simple point tracker without bells and whistles that can be printed in a few minutes.
The following can be configured using the OpenSCAD customizer:
- Number of rings (2-digit and 3-digit STL included)
- Font and font size
- Depth of the digits (can be negative to have them stick out instead)
- Clockwise/Counterclockwise direction
- Height of the disc and width of the rings
- Size of groove between rings
- Overlap between rings for the internal notch
- Tolerance between rings
In my experience the inner arrow ring needs some extra tolerance because there is less leverage to separate it after printing. 0.3 mm between digits and 0.4 mm for the arrow ring worked well for me.
Recommended Settings:
- Disable supports
- Randomized Z-Seam
- Ironing for the top surface
There is no snapping for the numbers, so this also works as (bad) fidget-spinner.