Ram Mount Compatibale Stem Mount for Yamaha R6
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this for my '08 R6 because I didn't like the options offered.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 110
- Wydruki
- 0
- Wyświetlenia
- 1261
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this for my '08 R6 because I didn't like the options offered. So far its held up fine going 70+ mph while holding my 1+3T.
Update: I am nearing toward the end of a full riding season and have used this mount every time I was on my bike. Still holds up great and shows no signs of failure.
Update2: Checking in a little into my second season with this mount. Same mount still holding up fine.
Print in PETG/ABS/outdoor friendly material.
Print the ball touching the build plate.
Uses M5x60mm screw and lock nut.
Should fit any handle bar stem 14mm in diameter. May fit slightly bigger diameters.
If you wish for different sizes:
Download the Fusion360 archive (.f3d) and edit the parameters to suit your needs.
Connector shown in pictures by onasiis.
Print instructions
Category: Automotive Summary
I made this for my '08 R6 because I didn't like the options offered. So far its held up fine going 70+ mph while holding my 1+3T.
Update: I am nearing toward the end of a full riding season and have used this mount every time I was on my bike. Still holds up great and shows no signs of failure.
Update2: Checking in a little into my second season with this mount. Same mount still holding up fine.
Print in PETG/ABS/outdoor friendly material.
Print the ball touching the build plate.
Uses M5x60mm screw and lock nut.
Should fit any handle bar stem 14mm in diameter. May fit slightly bigger diameters.
If you wish for different sizes:
Download the Fusion360 archive (.f3d) and edit the parameters to suit your needs.
Connector shown in pictures by onasiis.
Print Settings
Supports: Yes