1 / 5
Desiccant Tray for Bambu Lab AMS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A desiccant tray for storing loose silica in the Bambu Lab AMS.
- Ocena
- 4,97 / 5
- Polubienia
- 1433
- Pobrania
- 18 684
- Wydruki
- 162
- Wyświetlenia
- 50 725
- Oceny
- 134
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 162) (Komentarze: 187)Remiksy (2)Kolekcje (2527)Powiązane
This was a well designed model but I didn't like that it was too tall to use with the stock cover. While I was shortening it I saw room for some improvements so I made the following changes:
- Reduced overall height just enough to fit the stock cover
- Added nubs to retain the desiccant tray cover in the tray
- Split the cover in half so you can leave the bottom cover in place and load even more desiccant
I super glued the bottom covers to the tray in my setup but it's not necessary.
Get your Prusameters… Post your Makes!
If you like this project, please don't forget to ❤ Like and ★ Rate!
Printing tips:
- Print everything with the flat side down
- Supports are not needed
- Use a fine layer height and outside/inside wall ordering for best fit and finish