Park Tools Y wrench holder for pegboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple holder for the classic Park Tools Y wrench.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 235
- Wydruki
- 3
- Wyświetlenia
- 1170
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple holder for the classic Park Tools Y wrench. Holds the Y wrench slightly away from the pegboard and tilted out so it's easier to grab and they can be mounted closer together (as in the photo) without interfering.
Fits newer style Park Y wrenches. Older ones have a smaller center section and will still fit but not quite as well.
Designed to fit particle board pegboard with 1/4" holes on 1" square pattern. Some pegboard may say 1/4" but if the holes don't measure right around 6.35mm then no guarantees.
Print instructions
You can have supports for the pegs, but I usually don't bother. The bottom of the top pegs will be a little rough, but I find it helps hold it in the pegboard a little better. I've printed at 0.3mm layer height with no issues. The underside of the front curved part might wind up a little messy printing at large layer heights, but once it's on the pegboard you won't notice it.