Menuett food slicer blade drive gear
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Blade drive gear for Menuett 802672 food slicer (Skärmaskin) and other clones.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 168
- Wydruki
- 1
- Wyświetlenia
- 975
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
About
This model is a replacement for the the Menuett multi-slicer drive gear - the one that transforms the worm gear spin to the main blade. It turns out it is pretty easy to strip the gear.
The slicer design seems to be also popular on AliExpress
I've bought mine in Jula, the article number is 802672. Other names for this appliance are:
Viipalointikone
Skärmaskin
Skjæremaskin
The gear parameters are:
Helix gear:
- teeth: 40
- outer diameter: 42mm
- 10 degree counter-clockwise helix
Smaller gear: 11
- teeth: 11
- outer diameter: ~20mm
Overal height ~31.2mm
Shaft diameter is 6.5mm, I had to chase it a bit with a drill bit to make it fit nicely. It can't be too snug.

Printing
- I've printed mine using Fiberlogy PA12 Nylon.
- I've tried PLA, but it stripped on me quite quickly.
- I've used a Bambu P1P printer with standard print settings.
- I've used auto supports, as the bottom area seems to be a bit small, so proper plate adhesion was a bit of a challenge without supports/brim.
Installation
I'm not an electrician or electrical engineer. I don't know what I'm doing, but here are the steps I took to replace the gear:
- DISCONNECT THE DEVICE FROM POWER
- Remove the blade, using the locking ring in the center.
- Use a T20 torx screwdriver to remove the 4 fasteners hidden under the blade.
- Pry the plastic cover a little, should pop right off.
- Remove the broken gear, it slides right out from the shaft. Make sure you keep the thin washer, which is also the bearing for the gear.
- Shim the gear with another flat washer (I used a standard 6.3mm washer), this helps the gear to stand off nicely. I think there is a bit more flex in PA12 than the original gear material, which caused it to rub and eventually strip.
- Apply a food safe grease to the shaft and inside the new printed gear.
- Replace the cover and fasteners and the gear
- Slice some delicious bread!
Enjoy.
