E3D_V5_MT Modular hotend mount for the Ultimaker Original

A split mount for the popular E3D V5 hotend that can be replaced without removing the gantry rods (after first removing the original mount).

Drop in compatible accessory mounting holes for the Annular Cooling V2 (http://www.thingiverse.com/thing:124237)

Has a dove tail accessory rail where a depth gauge attachement can be slotted in. See attachment photo.

A finned bracket is also provided if you want to better confine the airflow over the radiator fins and drop their temperature a few more degrees.

Print instructions

Category: 3D Printer Extruders Summary

A split mount for the popular E3D V5 hotend that can be replaced without removing the gantry rods (after first removing the original mount).

Drop in compatible accessory mounting holes for the Annular Cooling V2 (http://www.thingiverse.com/thing:124237)

Has a dove tail accessory rail where a depth gauge attachement can be slotted in. See attachment photo.

A finned bracket is also provided if you want to better confine the airflow over the radiator fins and drop their temperature a few more degrees.

Instructions

• 2x LM8LUU linear bearings (or the ones comming out of the old mount)
• 4x M3x45mm bolts
• 2x M3x10mm bolts
• 4x M3x20mm bolts
• 2x M3x30mm bolts
• 12x M3 nuts
• 2x 2.5x1mm cable ties

• 1x Annular Cooling V2 (http://www.thingiverse.com/thing:124237)
  For the dial gauge rail:

• 1x M4x20mm bolt

• 1x M4 nut
• 1x M3x20mm bolt
• 1x M3 nut

• 1x Dial gauge
  Print all parts on their larger flats although some can print on their sides. Keeping the same print orientation makes a better stack.
  You can print all parts at 50% infill and 0.2mm layer thickness, but I prefer printing the bracket at 100% infill, especially the thin square one.

  Enjoy!