Calibration Kiki
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A calibration print/toy based on my character Iekika
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 120
- Wydruki
- 8
- Wyświetlenia
- 490
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to create my own personalized calibration print, so I took the standard 20mm cube and turned it into a little model of my cyclops-monster character, Iekika. (Seen below)
The base cube is 20mm to a side, and other features dimensions are given in an image supplied above. This print is a good test of dimensional accuracy, 45 degree overhangs, small bridges, corner roundness, and due to the low surface area contacting the print bed, bed adhesion.
Additionally, you can stack multiple on top of one another! This is… maybe a test of tolerances? Honestly it's mostly for the fun of it.
On my Ender 3 v2 it takes about 35 minutes to print at 0.2mm layer height.