Saitek X52/X52 Pro Spring Spacers(various sizes) + Installation Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted a Spacer for the X52 that did not touch the inner spring of my X52 Pro. Blechimmers version was the only one…
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 464
- Wydruki
- 2
- Wyświetlenia
- 1368
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Wanted a Spacer for the X52 that did not touch the inner spring of my X52 Pro. Blechimmers version was the only one that did that for me, but it was a bit soft so I remade it in a few different sizes:
0.5mm
1.0mm(same as Blecheimers)
1.5mm
2.0mm
2.5mm(same as 3DYeti)
3.0mm
3.5mm
4.0mm
4.5mm
5.0mm
5.5mm
6.0mm
I didn't try all off them but I think I'll stick with 3mm which is a nice medium. The biggest I tried was 6mm at which point it starts to inhibit the range of motion of your stick, you probably shouldn't use any of the ones bigger than 5mm which worked fine(didn't try 5.5mm).
They should fit on both the regular X52 as well as the X52 Pro.
For easy installation I also made an installation/removal tool.Simply pull the spring a bit down and push the tool in with the Text facing down, then use the tool to pull both springs down and insert the spacer. When switching or removing a spacer put the tool into the spring right bellow the spacer with the Text facing down and then turn it counterclockwise till both spring sit against it. Then you can just push it down and pull the spacer out, Leave the tool in if you want to install another spacer, then remove it after installation.
Print Settings
Printer:
Bibo 2 Dual
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
100%
Filament:
Bibo PLAWhite
Notes:
You can increase or decrease the layer-height as you like as long as you stay bellow 0.25mm, it should work fine either way.
You can also probably reduce the infill to 50% or even 20% especially on the smaller ones it doesn't make much difference so I simply printed them all at 100%Make sure to print the Installation tool at 100% though.
Category: Video Games