Prusament spool holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder especially for a Prusament standard spool.
- Ocena
- 4 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 1
- Wyświetlenia
- 363
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
A spool holder for Prusament rolls. Other rolls in the same dimensions will probably work fine too, but I designed and use this one only for my Prusament spools.
Prints with support everywhere. I use infill 40, and it's really sturdy. Gcode provided.
It uses 4 x 608z bearings.
Post-printing you will need a utility knife to scrape of a little bit of the support that still sits on the bottom of the holders for the bearings to make the mounting of the bearing fit nicely. It comes with four countersunk screw holes for safe mounting. Mine is mounted in top of my LACK enclosure, and that works very well.