Probably most overengineered tea dispenser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is probably the most overengineered tea container that I had made - but it works!
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 1332
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Hello!
This is a container for a loose tea. It has several parts, and you will need a bit of cyanoacrylic glue and two stripes of scotch tape to finish a built and secure it in the chosen place. I have printed it using two colors, because it looks nicer.
Parameters:
PLA
layer high: 0,28
Fast profile from CHEP
After you will print it, you start with mounting a spring in the main body. Then you glue a separator (see the picture) to the spring. Next step will be snapping the vessel (be careful to not break the main body hinges!). When you will insert the inner part, you will be able to see, how the separator works when you pull the spring in and out. Then you can add some scotch tape to the mounting, add a tea to the container and mount it in your kitchen (or other place).
Then you move the spring, tea is falling into the container, pull the spring to block the tea. If it clogs, use a toothpick to move the stacked tea. When you spin around the vessel, the tea will drop to your cup. The next step you probably know ;)