5$ Leopard Imprint Litophane Lamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this as a gift for my girlfriend, It's easy to print and it fits right onto a 5$ lamp from Jumbo.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 343
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
READ THE DESCRIPTION!
NO SUPPORTS NEEDED! Softwares used: Litophanemaker.com / Meshmixer / Solidworks
You need to buy the following lamp which costs approximately 5$ from the store “Jumbo”.
Materials:
I used PLA and that's okay but only use it with LED lamps! Because of the temperature. I used Marble color but I suggest you using just white. It would be better for a litophane.
Settings used:
- No supports
- Infill: 10%
- Layer height: 0.2 but you can go lower
- Perimeters: 2
- Speed perimeters: 45mm/s
- Small perimeters: 25mm/s
- Bridges: 20mm/s
If you want to create something similar I used the following settings on litophanemaker.com:
Litophane parameters
- Lithophane Resolution (mm/pixel): 0.3
- Top Diameter (mm): 125
- Bottom Diameter (mm): 155
- Number of Half-Waves: 0
- Size of Waves (mm): Irrelevant
- Height (mm): 130
- Base Width and Height (mm): 4
- Overhang Angle (deg): 45
- Maximum Thickness (mm): 1.2
- Minimum Thickness (mm): 0.4
- Spacing Between Pictures (mm): 0
- Spacing Brightness [0-1]: 1
Frame Options
- Clamp Interface Ledge Interface
- Ledge Diameter (mm): 37.2
- Ledge Height (mm): 30
- Cylinder Diameter (mm): 79.5
- Cylinder and Ledge Thickness (mm): 4
Spoke Parameters
- Spoke Thickness (mm): 4
- Spoke Depth (mm): 4
Texture used:
If you are using the same lamp, you need to create a cylinder in the middle of the ledge with an inner diameter of 37.2mm and an outer diameter of 46.8mm. This cylinder eliminates the need for support and allows the lampshade to be snapped into place.